For the fabrication final, I thought I would use some of the tool I had yet to use this semester. The bandsaw. To do this I could use up the dowel I had from last week’s not so dumbbell project. I am going to make a robot.
I am beginning with a dowel and a wire hanger both of which I cut to small pieces.
Then I drilled the holes to plug the wires into. I ended up with something like this.
Then I apply the paint.
Then some JB weld to connect the parts together on a more permanent basis.
Also, I found out that I needed to use JB Weld from the thistothat.com website which lets you know how to attach one material to another.
Finally I add some special components to the robots and this is the final result.
Good work. I like that you used the already existing bends in the wire. I wonder if you could take that further, with the twisted part in the hanger for a neck, or maybe use the curved part in some way.
thistothat.com is a very useful site.
Are you planning on hitting them with a clear coat of some kind? To protect the paint job.